You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 1236 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 10 posts

Sunday, June 12th 2011, 11:44am

by rockstar

battery

trying to figure out why my battery only last about a day or two then i have to replace anyone have any ideas on what's going on ?(

Wednesday, May 4th 2011, 8:06pm

by Wet_Boots

AC current readings are kind of advanced, and a lot of multimeters don't even have AC current as an option. If the system works 100 percent, there's nothing for you to find. If a zone with a 20-ohm solenoid trips the 'breaker' you measure its resistance, and look to see a reading of at least 20 ohms. A lower reading would indicate a short. A zone with two valves would be more likely to be an overload.

Wednesday, May 4th 2011, 7:53pm

by John Wig (Guest)

Thanks Boots, but....

You kind of lost me on the last one. Set to AC...connect to the controller common and to the system common...what do I look for there??........Also....the zone in question (which is actually 2 valves because two wires are connected to that zone) it worked today....????

Wednesday, May 4th 2011, 11:54am

by Wet_Boots

You already measured the resistance of a brand-new solenoid (didn't you?) so you can disconnect the common wire from the controller, and start taking resistance measurements of the individual zones. Faulty wiring should show up here.

-

Even more advanced, is to set the multimeter to AC current, and connect one lead to the controller common, and the other lead to the (already removed) system common. Current readings tell you the most, as the system will operate as normally, and intermittent problems can make themselves known, as solenoids heat up.

Tuesday, May 3rd 2011, 6:31pm

by John Wig (Guest)

OK.....Boots....

I just replaced all my selonoids in the system as they were like 15 yrs old. I rewired and put new waterproof wire nuts. So, go ahead boots...what should I be looking for with the multimeter???



JW

Tuesday, May 3rd 2011, 4:17pm

by mrfixit

Once you find which valve it is you're going to have to undo the connection to test the solenoid just like I suggested. I'll let Boots tell you how to test using your meter.

Tuesday, May 3rd 2011, 3:08pm

by John Wig (Guest)

Clarification

Guys,



I know how to use a multimeter. It's not hard and I have a good one. What should I be looking for for ohms and volts.....? I would rather do that than undo good connections, if I can test at the box.

Tuesday, May 3rd 2011, 2:46pm

by mrfixit

I KNEW IT!

Tuesday, May 3rd 2011, 1:45pm

by Wet_Boots

I get a kickback, what else? :P

Tuesday, May 3rd 2011, 12:39pm

by mrfixit

Why make a homeowner go out and buy a multimeter when it's a simple diagnosis.