You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 2627 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 2 posts

Friday, April 15th 2011, 5:08pm

by Wet_Boots

You have to know both the output of your well system, and the demand of your sprinklers. Often, a system demands more than a well can deliver. The pump can supply enough flow, but the water level in the well can drop to the point where the pump is, and that is when the performance drops drastically.


The above is for a deep well with a submersible pump. If you are operating from a well point, the same general principle applies. Water level too low, and performance is reduced.

Friday, April 15th 2011, 12:10pm

by Lora Beth (Guest)

Pressure Dropping

Our irrigation system is on a well. We get good pressure for the first 3 minutes or so, then we have a drop in pressure and our sprinklers do not work efficiently. We are not technical with pumps, irrigation etc. and are hoping for some feedback before having someone come out to look at the system.