You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 2625 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 2 posts

Tuesday, April 12th 2011, 1:59pm

by Wet_Boots

Bring back some photos

Tuesday, April 12th 2011, 1:38pm

by groundskeeper (Guest)

Pressure Vacuum Breaker

Hi from Oregon, great site will definately be back for the forums.

So I had a valve blow out over the winter and I just replaced it problem is it was part of an assymbly that is connected to a pressure vac breaker. Turned the system on and everything seemed fine however a small amount of water is still seeping out of the breaker too much to leave it be. My guess is a sticky part in the breaker is causing something not to sit right. Any ideas?