You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 2595 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 5 posts

Tuesday, April 12th 2011, 12:45pm

by mrfixit

Tuesday, April 12th 2011, 12:14pm

by Wet_Boots

The original heads may have had low-angle nozzles, or something else other than standard issue. You have to match the nozzles.

Tuesday, April 12th 2011, 10:45am

by malzen

Thanks for the reply. Just so I am completely sure of what I need, any chance you could provide some links to what I would need? I looked at Lowes and Home Depot and I didn't see quite what I needed based on your response. Thanks in advance.

Tuesday, April 12th 2011, 10:00am

by mrfixit

Just use a reducing bushing from 3/4 to 1/2 inch. Then use a 1/2 inch nipple or swing joint. You're set to go.

Tuesday, April 12th 2011, 8:32am

by malzen

Really Confused about Rain Bird 5000 Series

I have some sprinkler heads in my back yard that I need to replace and on the top they say Rain Bird 5000 series on them. I bought 2 replacements and noticed that they are rated at 25-50 foot which is WAY to much distance for the size of my yard. I am curious, how is it possible that the current ones that are installed spray so much lower than the ones that I bought? Even setting them to the lowest distance possible (25ft) on the new ones that is still too far. additionally, I bought some heads that are rated 18-26 ft and the inlet is only 1/2 inch and I need 3/4 inch as that is the size of the pipe that I have in the ground. I am definitely confused... Any ideas?