You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 1351 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 6 posts

Sunday, April 10th 2011, 2:08pm

by Mitchgo

My response to the op ....

Is the controller plugged in?


don't mean to be a jerk, but stupid questions get stupid answers

Sunday, April 10th 2011, 2:06pm

by Mitchgo

I simply just don't understand how someone can come onto a forum and ask the most generic vague question about a specific problem..This is for all forums too, I mean if they were smart enough to find the forum, couldn't they have had done a little bit of research first? Or at least explain it in detail

Sunday, April 10th 2011, 1:20pm

by hi.todd

Mitchgo short on patients the other day I noticed. The duct tape and all.

It is hot out there. Time for some Iced Tea.

Lets all have a good week.

:thumbup: :thumbup: :thumbup: :thumbup:

Sunday, April 10th 2011, 2:39am

by Mitchgo

You have much more patients then me :D

Friday, April 8th 2011, 11:38am

by mrfixit

Is the controller putting out power to valve 4?

Is the valve receiving power from the controller?

Is there water at the valve? Open the bleeder screw if there is one.

Is the flow control turned off?

If you haven't found the problem yet then the valve needs repair or replaced.

Thursday, April 7th 2011, 4:37pm

by 5IVE

Zone will not come on

I have a zone that will not come on at all it's zone #4. any answers.