You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 4418 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 2 posts

Monday, May 15th 2006, 6:22pm

by Wet_Boots

It can be just that simple. Then again, if you have certain old kinds of valves, it may not be so simple. Some of the old brass valves, like Imperial, had high-current solenoid coils, that will just short out many solid-state controllers.

Monday, May 15th 2006, 5:55pm

by lbroyles

replace electromechanical controller with electric

Can I simply replace an old (very old 25+ years) electromechanical controller with a new modern electric controller? Is it as simple as intalling the new controller and wireing it? Or is it possible that the valves would not be compatable? I've never worked with an electromechanical controller before.