You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 2641 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 2 posts

Sunday, March 27th 2011, 10:36pm

by Mitchgo

Try doing a reset on the controller, disconnect the backup battery too

Sunday, March 27th 2011, 4:00pm

by MarkTX (Guest)

worked before winter now not so much

I have a Hunter-ProC. It's about 9 years old. It worked before winter, now not so much. No digging Nobody messing around with the system. I turn it on manual zone 1 and it turns on 4 while giving me a Op Error then a P Error. The water does spray. If I turn it on zone 3 it turns on zone2 while giving me the same error with water. I went to the board and tightened down all the connections at the controller. Made sure all the connections are tight at the pump (can't really see where the wire goes). I don't think this is the problem since it's letting water thru the system with pressure. Thanks in advance for your help.