You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 1374 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 3 posts

Wednesday, March 16th 2011, 7:07am

by Wet_Boots

There should be an isolation valve between the pump and the system, and a drain valve between those, which will let you more easily prime the pump. Let the air exit the system by way of the drain valve, then open the isolation valve.

Wednesday, March 16th 2011, 12:15am

by Mitchgo

It's all with the pump and the intake line.

There is air in the pump or intake line that you need to get out.

Basically you need to reprime and get all the air out, the easiest way is to have a hose connection set up just a little after your foot valve of the intake line and connect a hose up to it. This way your pushing the water and air through the intake line instead of just filling the line up at the pump with air still inside. Then continually turning on/ off the zones until the pump is primed. Sometimes if you manually turn on several of the zones ( Still within the limits of the pump) this helps pushing the water because it's asking for more demand

Tuesday, March 15th 2011, 12:10pm

by tbtlend

pressure

system draws water from a lake. recently pulled the screen from mthe lake to clean. water drained from system. upon restart water pressure appears to increase and decrease intermittently as heads pop up full force and gradually lower back down. not water hammer as no sound is heard.

Does this mean there is air in the water lines? If I run the system will it eventually clear out or will I burn up a pump?

Do I need to bleed air in some way?