You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 2856 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 2 posts

Tuesday, August 24th 2010, 1:08pm

by Fireguy97

Stanley, can you find and get into your irrigation valve box? Do you know what a manifold is?

If you can, then there are only a few items that could be there. Backflow prevention assemblies, shut off valves, filters, and master valves.

If you have a manifold, then you would have a manifold, irrigation valve(s) and the wiring. The valve is the item that the wiring is connected to. An irrigation valve can be in a variety of shapes.

If you have a weeping valve, it is probably caused by either debris in the valve, causing the diaphragm to not seal properly, or a faulty diaphragm.

You can try to open up the valve and see if there is anything in the valve. Shut the water off first. Sand, dirt or small pebbles can also cause the diaphragm to not seal, so the debris can be very small. If your diaphragm is faulty, you can replace it.

Normally when I go to a service call with a weeping valve, I will do an inspection and a quick clean out. Other than that, it's less expensive for the client if I just replace the guts and upper portion of the valve. With the cost of the valve, and labor rates, it's less for the client than taking expensive time searching around for a diagnosis to repair a cheap part.

If you replace the diaphragm or the valve guts, the valve parts will have to be from the exact same make and model as you have in the ground now.


Monday, August 23rd 2010, 11:18am

by stanleyB

What is a "weeping" zone valve?

A 24/7 leak from a low head would be caused by a "weeping" zone valve.

I think I have the same problem as the person who received the above answer. I imagine that the zone valve is at the manifold. What does it look like and how do i fix it... Thank you