You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 2827 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 2 posts

Saturday, July 24th 2010, 3:52am

by Wet_Boots

You can rework the plumbing so that the pump boosts pressure for the entire house, including a pressure switch and a pressure tank large enough to prevent cycling of the pump when the indoor water use is low. The relay would no longer be needed.

Friday, July 23rd 2010, 1:46pm

by Angie (Guest)

No water flow in home when pump supported sprinkler system is operating

We just installed a sprinkler system with 4 zones and approximately 8 heads on each. We purchased a 1 hp pump and relay switch to boost water pressure because we are in the country with a rural water supply. We tested pressure before installing the system and the average of three readings was approximately 45 GPM. The system operates great. We have full head to head coverage with only one problem...When the pump is running there is no water in the house. What could be the problem?? ?(