You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 1370 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 4 posts

Monday, July 19th 2010, 4:16am

by mrfixit

You don't need a whole new valve. Just get a new solenoid if the wire's too short to repair. And yw.

Sunday, July 18th 2010, 3:58pm

by blakeLake

Hunter SRC

mrfixit
You are a genus, I noticed one of the wires on the valve is broken right where it is attached to the valve, the one attached to the common line, I suppose now I will have to replace the entire head, which is not so bad

Thanks, one problem solved, now all I have to do is learn how to replace the valve

Sunday, July 18th 2010, 4:34am

by mrfixit

Here's what I do. I start at the controller. Make sure the wire on number two isn't loose or broken off. Then make sure the number two terminal is putting out power when it's supposed to. I have tools for that but I'm going to assume you don't. Simply move the wires around. Move the number two wire to the number 1 terminal and see if the valve comes on and visa versa. Ok you've determined the controller is alright. Now go out to the valve and see if the valve is receiving power from the controller. Check for loose or broken wires. Again you can move the wires around and see what happens. If you have power the problem is the valve. No power the problem is the wiring.

Good luck!

P.S. you don't need a "Hunter" guy to fix the problem. Any irrigation guy can do it.

Saturday, July 17th 2010, 8:45pm

by blakeLake

Hunter SRC

Station 2 of 5 stations is not coming on, whenever the other station comes on I can hear it in the water line pressure, however when No 2 turns on there is no sound from the main line, non of the three heads pop up, any ideas on what I should do There is one guy in Northern Ohio who fixes Hunter it is like pulling tooth to get him to be punctual so I no longer call him