You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 3127 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 8 posts

Friday, July 2nd 2010, 8:29am

by Wet_Boots

Make sure the manual operator is not slightly open - you might have to disassemble it and clean out debris.

Thursday, July 1st 2010, 12:56pm

by jaredb0423 (Guest)

Okay pretty sure i have narrowed it down to this one.

12024EF-10-H - Weathermatic 1 inch 12000 Silver Bullet Series Plastic Control Valve with Flow Control

thanks for your help wet boots

Thursday, July 1st 2010, 12:47pm

by jaredb0423 (Guest)

I take that back....a 12000 series

Thursday, July 1st 2010, 12:46pm

by jaredb0423 (Guest)

It is a weathermatic, not 100% sure on the model but i think a 21000 series

Wednesday, June 30th 2010, 8:55am

by Wet_Boots

A master valve is an additional layer of shutoff-protection. But still, a brand-new valve, properly installed, should shut off reliably on its own. What make and model of valve are you dealing with?

Wednesday, June 30th 2010, 6:48am

by Jaredb0423 (Guest)

I don't believethre is.

Tuesday, June 29th 2010, 9:27pm

by Wet_Boots

Is there a master valve in the system?

Tuesday, June 29th 2010, 8:51pm

by Jaredb0423 (Guest)

Leaking Valve/Sprinkler Head

I recently had a valve break and replaced with a new valve. The system will run and water just fine but once the system is turned off water still runs through the pipes and out of the head. It mostly goes out of one particular head, not enough for the head to pop up but a constant drip if you will. I can turn the water meter off and it will eventually stop leaking. but once I turn the meter back on within mins the water begins to leak out of that particular head. I have also changed heads and this did not correct the problem. Did the valve get put in incorrectly?? Please help and thanks!