You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 1393 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 2 posts

Friday, June 25th 2010, 6:35am

by Wet_Boots

buy another head already

Friday, June 25th 2010, 4:40am

by Len B

Toro Super 700 Rotor Adjustment NOT adjusting

I have an 18 yo system that is all Toro and uses mostly the Super700
rotors and need to change some of the arcs. I have only been unable to
change the arc setting on ONE of them. They are ALL part circle (red pin
under nozzle), I have unlocked the head and have followed the steps for
adjusting the arc. I know the technique works since I was able to
change 1 out of the 20+ heads I have. Has this been a problem with the
old Super 700 heads? Is there a way to correct this short of replacing
the heads or "using a six pound sledge hammer" as has been suggested by
some genius on this board? Is there a way to disassemble the rotor to
access the rachet mechanism (short of the the hammer technique
mentioned)?