You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 4 posts

Thursday, May 12th 2016, 7:17am

by Call-me-goose (Guest)

Thank you

I have gone through my manual several times and it did not explain that run times was not stations I had 4 stations and 4 run times so I just assumed it was 1 for each I was about to buy a new controller thanks again for saving me a couple bucks :thumbsup: :thumbsup:

Tuesday, June 22nd 2010, 8:30am

by Greenweenie

Thanks, mrfixit. After I posted my inquiry, I decided to try the technical assistance number to Toro. I was surprised to actually contact someone,who was helpful and courteous. (Kudos to Toro!)

The person who answered had me get in front of the timer/controller and she walked me through all the settings. Your analysis is spot on, as after this past winter, I found that I had to replace the backup battery (frequent power outages here with our less-than-adequate power provider). The programming had erased, so I reset everything. I made the error of programming separate start times for the two zones. Once I turned off the start time for what I thought was zone 2, the system now cycles and shuts off properly.

Monday, June 21st 2010, 1:41pm

by mrfixit

A reset might help but if the same person reprograms the controller you'll have the same problem.

Check the start times. You only need ONE "start" time. Then the valves will run in sequence and wont repeat.

Also check the programs A B C to see if they have extra start times. You only need one start time on program A.

You know what, maybe you should just reset it and start over.

Monday, June 21st 2010, 9:15am

by Greenweenie

Toro GreenKeeper 212 Controller Problem

I have developed a recent problem with my 2 zone system. The timer/controller is a Toro GreenKeeper 212. At the conclusion of the 2nd zone cycle, the 1st zone comes back on. Would a reset (unplug and remove the battery backup) be a reasonable course of action?