You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 1566 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 5 posts

Wednesday, June 9th 2010, 10:01am

by Wet_Boots

Can't be done - write down your settings, then reprogram the controller - it has been many years since controllers with separate switches for each zone have been sold, and if you could buy them today, they would be so expensive you would never spend the money.

Tuesday, June 8th 2010, 10:19pm

by wetfeet (Guest)

Shutting down a station

Anyone know how to shut down a specific STATION, while maintaining program settings?

Thursday, May 27th 2010, 1:55pm

by Wet_Boots

Turn the water on, and know that it is on by manually opening a valve without using the controller. Make sure a rain detector isn't preventing operation.

Thursday, May 27th 2010, 8:53am

by HooKooDooKu

Have you tried the basics?
1. Are ALL shutoff valves on? At a minimum, there should be a system valve that must be open, and your backflow preventer usually has shutoff valves on them as well. Typically, the handle for a shutoff valve must be turned so that the handle is parallel to the direction of water flow for it to be "on" (when the handle is perpendicular, it's like a wall, to stop the flow).
2. Will the zones come on if you try openning the control valve manually?
3. Is the controller properly plugged in with any fuses still in tact (I don't know about the Pro C specifically, but if a controller is on battery power, it might look like it's still functioning, but would not operate the zones because it doesn't have enough power, same goes if the fuse is blown, the fuse can be just for power to the valves and not affect the internal operation of the controller).

Wednesday, May 26th 2010, 7:52am

by anastarone

Hunter pro c

I just turned the water on on my Hunter Pro c after having it off all winter. When I turn the sprinkler system on I see the image of the sprinkler show on the display but they aren't popping up?