You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 3122 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 5 posts

Monday, May 24th 2010, 10:24am

by HooKooDooKu

You usually turn a zone valve on/off manually by turning the solenoid about 1/4 to so.

But I would tend to agree with Wet_Boots, sounds like the water is not on.
If your irrigation is on city water or well water connected to your home, there is usually a seperate valve to allow you to turn water off to the entire irrigation system seperate from the house system. If you get water from a lake, or from a well (while the home is on city water) there is likely a water pump that must be turned on (i.e. valves to water pump open, and a special terminal from the controler connected to a relay that turns the pump on and off).

Monday, May 24th 2010, 5:41am

by Wet_Boots

Find a zone valve and manually open it, then you will know.

Sunday, May 23rd 2010, 3:58pm

by FairMax

How do i manually operate it??

I think the water IS on.

Sorry, this is my first time dealing with this =)

Sunday, May 23rd 2010, 3:53pm

by Wet_Boots

Turn on the water. Prove that it is on by manually opening a zone valve. (not using the controller)

Sunday, May 23rd 2010, 3:21pm

by FairMax

Orbit System! Please Help! LOL

I moved into my house and the sprinkler system never worked. The thing is, the previous owner personally showed me the sprinkler system, and IT WORKED. This was just 1 week before i moved in. After I moved in, CANNOT get it working!

I replaced the Orbit controller with a new one. I bought 3 new Solenoids and connected them. Got new Wire Caps. The wires from the controller to the valves look a bit old, but should still work, don't look fried or anything like that.

I am at odds on what to do next. I am so confused. The water valve is right there by the controller and the valves, and it's opened.

I turn on the controller on Manual, and the controller goes through all the motions, tells me that the zones are being irrigated, the minutes count down, etc... When I change zones (or values) I hear the Solenoid "click" (which I guess it's good). One of the Solenoids makes a buzzing noise when clicked, but if I gently tap on it the buzzing goes away. Still, doesn't irrigate.

Anyone? Pleeeeeeasssee...