You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 1676 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 3 posts

Saturday, April 24th 2010, 11:19pm

by mrfixit

There was a post similar to this about 3 years ago. The guy was on a pump I believe.

All the valves were open not able to close because there wasn't enough water pressure to do so.

We suggested he turn the flow controls on all the valves all the way down then turn on the pump. Then open the flow controls one at a time. The valves shut off one at a time and his problem was solved. So give it a shot. Pump or no pump. Let us know what happens.

If you had a wire hooked up to the master valve terminal and hooked it up to all the valves for some reason then all the valves might come on when the timer is activated. If there's a wire hooked up to the master valve slot simply disconnect it.

Saturday, April 24th 2010, 6:07pm

by Wet_Boots

Your problem is mechanical - no controller involved. At worst, you will be replacing the zone valves. What make and model is in there now?

Saturday, April 24th 2010, 5:27pm

by flintknapper

All zones come on when water turned on, controller has no effect

All sprinklers in all zones of my system will activate when the water is on, the controller/timer has no effect. No master valve on system. Replaced the controller... no change. Fuse is not blown, outlet not GCFI, power to controller is fine. Shut off the water and removed a zone solenoid, activated that zone with the controller... nothing, no thump, no noise. I suspect the common wire from the controller to the valves is bad. Anybody want to offer an opinion? Help!