You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 1775 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 6 posts

Saturday, September 12th 2009, 8:49pm

by debo

Buy a shovel. Dig away the soil and add what fittings are needed to get the head to the proper height (which is a bit higher than you might think)

That would work...

I would dig uop the head and find the feed from main line to head. Fix it if using funny pipe. If not, add funny pipe .

Tuesday, August 4th 2009, 1:06am

by Wet_Boots

Buy a shovel. Dig away the soil and add what fittings are needed to get the head to the proper height (which is a bit higher than you might think)

Friday, July 31st 2009, 1:37pm

by mikemck

I have the same problem.

I am concerned about raising the rotor while the outer housing is still low.

I have a lot of problem with grass intruding into the housing.

Is there something I can use to extending the outer housing too?

Thanks.

Tuesday, June 16th 2009, 7:46am

by markedpaper

:) Thanks for your help!!!

Sunday, June 14th 2009, 12:39pm

by mrfixit

Riser extensions

These will do the trick. Dig one up to see what size you need. They have them at SprinklerWarehouse.com

Swing Joints:
http://www.sprinklerwarehouse.com/Hunter-Swing-Joints-s/6837.htm

Risers (Cut-Off Nipples):
http://www.sprinklerwarehouse.com/Cut-Off-Nipples-s/223.htm

Sunday, June 14th 2009, 7:41am

by markedpaper

Rotary spray head about 2 inches below surface?

Some of my hunter rotary spray heads are about 2" below ground level. X( I recently purchased this house and have no idea why some rotay spray heads are about 2" below ground level. ?( I had to dig around the spray head to make some clearance for the pop up. ;( The ones where I had to dig now look like golf course holes. ;( Is there a way to fix this problem without digging up the entire lines? ?(Do they make any type of extensions for the rotary spray heads? ?(