You are not logged in.

  • Login
  • Register

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 747 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 4 posts

Friday, June 3rd 2011, 7:49am

by Wet_Boots

Check every program on that controller - they generally only do what you tell them to do

Friday, June 3rd 2011, 5:11am

by Debbietex (Guest)

Zones keep repeating until I turn SRC control box to OFF

Zones keep repeating until I turn it to OFF. I have only one time set. Also I have tried running all zones manually and they keep repeating until I turn it off. Can you tell me how to correct this? Do I need a new control box.

Friday, May 1st 2009, 8:37pm

by mrfixit

Pilot error

Hi, what you have described is a common mistake people make when programming their controller. There's a good chance that you have programmed more than one start time. You only need one start time then the stations will run in sequence. What people do is something like this, start time one 6 am, start time two 6:15 am, start time three 6:30 am and so on. If programmed this way the controller will restart after the last zone finishes. Check your start times on all programs, ABC. Only the 6 am start time is necessary. The zone run times tell each zone how long to run not the start times. Good luck!

Friday, May 1st 2009, 2:52pm

by kxaz145

Hunter SRC-900i Cycles Through Zones, Won't stop

I bought a replacement Hunter SRC 900i controller a few months ago and it has never stopped after the last zone completed. It has 8 zones and i'm only using 6. After zone 6 shuts off, Zone 1 starts again and it will cycle like this until the switch is set to OFF.