You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 2024 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 3 posts

Tuesday, April 7th 2009, 1:16pm

by worachj

I use a Toro EZ-flow 2604 valve for drip line watering of my shrubs and plants around the house, works just fine. I connected a Toro 9 outlet distribution manifold that I bought at Home Depot to the valve which has a filter and 25 PSI pressure regulator. That’s all I use and it has worked great now for 4 years.

Quoted

9-Outlet Distribution Manifold
Features
• A 9-outlet distribution manifold which accepts Toro Blue Stripe Drip 1/4" Tubing.
• Perfect for watering shrubs or trees.
• 9 shut-off caps.
• Includes filter and 25 PSI pressure regulator.
• Contains a 1/2" NPT inlet.
http://www.amazon.com/IRRIGATION-53755-STRIPE-9-OUTLET-MANIFOLD/dp/B000UJH6F8



Quoted

EZ-flow 2604 Specifications
• Flow range: 0.25 – 30 GPM
• Operating pressure: 10 – 150 PSI

http://www.toro.com/irrigation/res/downloads/Res%20Valves/EZ-FLo%20Plus%20Series/ezflow_ss.pdf

Tuesday, April 7th 2009, 12:24pm

by HooKooDooKu

For drip irrigation, you need a pressure regulator and a fine mesh filter arrainged like this picture of an entire kit http://www.sprinklerwarehouse.com/Xerigation-0-75-inch-Low-Flow-Control-Zone-Kit-p/xcz075prf.htm(value, filter, & regulator). You MIGHT be able to use the toro valve, but I'm not sure. Some valves will not properly operate (i.e. close) if the flow isn't high enough. I tried looking for some details on a toro 2604 valve but wasn't able to find the details on them to indicate at what water flow rates the valve is designed for.

The kit shown above (sold by the sponsor of this web site and available at irrigation whole-salers like Ewing) includes a valve that is specifically designed for the low flow of drip irrigation.

Now I've had no problem using a rainbird valve designed for flow rates from 0.2 to 20 gallons per minute that simply supplies water to a single rose bush (likely about 4gph, which equates to 0.06gpm) without problems. So your existing valve might work. But depending upon the flow rate you plan to use, it might not.

Monday, April 6th 2009, 9:14am

by pszone

hello

Hello I currently have a sprinkler system installed at my house. My question is I want to install a drip line around my house for my plants etc. I currently have a toro ez-flow 2604 not being used would that work or would I need to buy another controller ,also would I need any other materials ,if so could anyone tell me else I would need thankyou

Frank