You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 2248 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 3 posts

Thursday, October 23rd 2008, 10:04pm

by HooKooDooKu

The old plumbers trick to create a bomb proof repair is four elbows. Basically, cut out enough pipe so that you can glue in 90 degree elbows on each end pointing the same direction. Then build a matching sized "U" with a few strate pieces of pipe and two more elbows. It's also a great way to fix a pipe that had a been and the results is two pipes that don't line up. In that case, so long as the pipes are level, you just point the elbows up and you can reconnect two horizonal pipes no mater what their angle is to each other.

Tuesday, October 21st 2008, 4:16pm

by mrfixit

either or

Both will work just fine. 80 lbs isn't too high for either device. I've installed many with higher pressure than that. Which is better? Beats me. I don't recall ever digging up a slip fix that's leaking. I have compression couplings but that could be from improper installation.

You might try tightening the fitting you have now. That might do the job.

Good luck!

Tuesday, October 21st 2008, 2:44pm

by jh (Guest)

Best fitting repair broken pipe

I've got a break in the main supply line, 1" Schedule 40, with no play to glue in a repair. Does anyone have any opinions on what is best - a compression fitting, or one of the telescoping fittings? I temporarily have an old compression fitting on at the moment, but it is weeping - not even dripping, but when I feel around it or put paper towel against it, I have just a tiny bit of water. Not sure if it will stop, or should I get new fitting, try telescoping, etc. It's reclaimed water from our city, so relatively high pressure - maybe 80 psi?

Thanks