You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 2116 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 2 posts

Monday, June 30th 2008, 2:25pm

by mrfixit

PGV wires

Hi Larry, those arrows are pointing in the direction you would turn the solenoid which will turn the valve on and off. For normal operation you want it closed (clockwise). Just turn it by hand til it's snug. The valve might shut off right away or take a few seconds. Give it a chance. The arrows aren't pointing at the wires. You can use either wire for the ground or hot. One wire will go to the common or ground terminal at the controller. One wire will go to the station number terminal on the controller.

Good luck!

Monday, June 30th 2008, 12:42pm

by LarryD

about hunter pgv valve

Trying to wire and understand the valve. On the top of this Hunter valve

I believe its the selenoid . It shows ON off arrows turn 1/4 & two wires.

How is this valve wired up and setup for use. It appears that the on & off arrows

point to a wire ?? Shoud the valve be turned 1/4 turn ??

Thanks for help

Larry