You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 3658 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 2 posts

Tuesday, June 17th 2008, 1:00am

by mrfixit

Low pressure

Try turning the valve on with the bleeder screw. If it works then the valve needs repair. Even if it doesn't work it could still be the valve. Listen carefully to see if you can hear the water rushing through the valve. --- Look for flooding. There might be a broken pipe or broke off sprinkler.

Monday, June 16th 2008, 4:10pm

by denverbuck

Zone 1 worked, but now not enough pressure

Each year I do some upgrades to the parts of my rainbird sprinkler system. Last year I did replace a few of the rainbird nozzles with adjustable spray heads (more GPMs). I did notice afterwards it took a good 5 -10 seconds to get going but it worked. Now it’s a new season and I can’t get any pressure into zone1. The heads just spit out fountains of water around the edges. My upgrade for this year was that I re-ran part of the copper 3/4 line from the mainline to the PVB outside. This was done so I could get the pipe out of the way so I can finish the basement. I am wondering if anyone has advice to get the pressure back into the zone? Did I do something wrong when I re-activated the system this year? I have a pressure regulator after the meter and I screwed the setting to the highest possible level but doesn’t seem to help