You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 3668 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 2 posts

Sunday, June 1st 2008, 10:35pm

by mrfixit

Bad solenoid.

Solenoids rarely go bad unless the wires break off. At least that's the case in my area. Others on here say differently. In your case though if you touched it to the controller where you knew there was current to activate the solenoid and nothing happened, sounds bad to me. As far as the diaphragm looking different I wouldn't worry about that yet. Sounds like the solenoid. If you change the solenoid and still have problems I'd double check to make sure you've installed the diaphragm and bonnet correctly. Then again your valve is very old. You can buy a new valve for about the price of a diaphragm and solenoid.
Good luck!

Sunday, June 1st 2008, 4:57pm

by k9fxr

Failed valve....solenoid?

Dont see a brand stamp but it has a round solonoid, has 8 screws in the top, green, prob 25-30 yrs old.
It is staying on even with system off. Took the top in to the local dealer, bought a new diaphragm (which didnt look like the old one), replaced it in its correct orientation. Tested it, did fine shut off.
Buried everything-..doesnt work.
Dug up, all connections seem fine, I tried to get the solenoid to click by removing and touching the wires to the control box and to the transformer directly...nothing

so is it a bad solenoid??